The Makita Genuine 1913N6-6 Boundary Pegs are a 50-piece set of wire fixing pegs designed to secure the boundary and guide wires of the Makita RM350D robotic lawn mower firmly to the ground. These are the same pegs supplied with the RM350D as standard, making them the correct genuine Makita replacement accessory for both initial installation and ongoing maintenance of the wire layout. Pegs are the primary method for holding boundary and guide wires in position across the lawn. Without them properly seated, wire can lift from the surface, shift over time, or be displaced by mowing activity — any of which can interfere with the RM350D’s navigation signal and cause the mower to stop or behave unpredictably. Makita recommends driving pegs at approximately 1m intervals along the wire run, with narrower spacing wherever the wire is prone to lifting — particularly on curves, slopes, or in softer ground conditions. The 1913N6-6 set is the practical choice for installing the RM350D on a larger perimeter for the first time, extending an existing wire layout, replacing pegs lost or damaged during garden maintenance, or re-securing wire after ground disturbance. With 50 pegs per set, there is sufficient coverage for a substantial wire run, and keeping a spare set to hand ensures the installation can always be maintained to the correct standard. Features and Benefits: • Genuine Makita accessory — the same pegs supplied with the RM350D from the factory • 50 pegs per set, providing coverage for a substantial boundary wire run • Correct specification for securing both boundary and guide wires • Suitable for initial installation, wire extension, or replacement after damage or ground disturbance Specifications: Quantity: 50 pegs Compatible model: Makita RM350D robotic lawn mower Recommended spacing: Approximately 1m intervals along the wire run